AEI Security & Communications DGHDP1 Manual de instrucciones descargar pdf (Pagina 18)

Page 18 Please read the instructions carefully prior to installation

DGHDP1 - DigiSender® HD Pro - Single Input Powerline AV Sender System

(EN) ENGLISH

Advanced Procedures

Transmitter & Receiver Syncing

The Transmitter & Receiver Syncing procedure should only be used when installing an Additional Receiver or

during Troubleshooting.

There are two ways in which the Transmitter and Receiver can be ‘Synchronised’ or ‘Synced’:

• ‘Sync’ using the buttons on the Transmitter and Receiver:

1. Press and hold the Group Button on the rear of the Receiver until the message “SYNCING” is

displayed on the receiving TV.

2. Press and hold the Group Button on the rear of the Transmitter for 2 seconds until the Sync and

Power LEDs blink sequentially.

If the Sync is successful, the message on the receiving TV will change from “SYNCING” to “SYNCED”,

followed by the video (providing that the source device is currently on and media is playing).

• ‘Sync’ using the remote control:

Press the Group Button on the DigiSender® remote control to sync the Transmitter and Receiver.

Note: It is highly recommended that you perform the above procedure with both the DigiSender® Transmitter and

Receiver in the same vicinity, preferably attached to the same dual-socket mains power outlet.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 111 112

Sin comentarios

AEI Security & Communications DGHDP1 Manual de instrucciones Pagina 18